52
CAUTION
Hard Disk Drive
To Change Your Hard Disk Drive, Contact Panasonic Technical Support
To customers:
To change your hard disk, contact Panasonic Technical Support.
Be sure to back up all important data before the change.
If [Hard Disk Lock] is set to [Enable] in the Setup Utility, change this to [Disable]
before the change.
To technicians (at Panasonic Technical Support):
Be careful when replacing the hard disk. The hard disk is extremely sensitive to
shock. In addition, static electricity could later affect some internal components.
Installing/Removing the Hard Disk
(For technicians at Panasonic Technical Support)
1 Power off your computer ( "Starting Up/Shutting Down")
Do not shut down using the standby or hibernation function.
Disconnect the AC adaptor.
2 Remove the cover ( page 34)
3 Removing the hard disk
Slide the hooks of the hard disk toward the inside.
Pull the tab A and release the hard disk from the connector.
Pull the tab B up and gently lift the hard disk.
Installing the hard disk
Insert the hard disk as shown in the figure.
Push the base part of the tab A and firmly connect the hard disk
to the connector.
Slide the hooks of the hard disk toward the outside.
Close the tab A.
4 Put the cover back into place ( page 35)
Tab A Tab B
Hook
Connector
To Next Page
Loading...
