Panasonic TX-22LX2 - Basic Controls: Top Panel and Remote

http://servis-manual.com/
9.1.1 RF video
TOP PREVIOUS NEXT
1.Receive full color bar by RF signal input.
(Aspect mode : wide, Viewing mode: standard, LCD AI: OFF)
2.Go to "Auto Y Gain" under Service 1 and make automatic adjustment of video signal level by
the blue key.
¡
When Service 1 appears, presetting takes place automatically as shown below.
¡
Sharpness: 0
¡ AI: OFF
¡
3D-Comb filter: On
3.Press STR key to write the value of adjustment results to EEPROM.
4.Check that the automatic adjustment of video signal level has completed normally.
¡ When the adjustment is completed normally, the "Auto Y Gain" color turns black.
Note:
In the adjustment mode, the M2 MCU changes automatically to the mode shown in the left.
TOP PREVIOUS NEXT
Instrument Name Connect to Remarks
Remote controller
Internal signal (studio color bar)
RF input
All manuals and user guides at all-guides.com