Panasonic TX-29FG50A - Video and Audio Connections; AV Input Terminals; DVD Player Input; AV Monitor Output

-t
(~~~
.How to connect the" A V1, 2 or 3" Input Terminals
["AVilmT"iNl~
l!f!J~~
0 0 yo 0 VIDEO
*'" *'"
C 0"0 Oll
AOOK>
01 0"0 O~
(VHS VCR)
~ ~-=~ ~
i-if; "CEO
==
rAVi1
~
.~O
-
~O
~O
AUDIO
Notes:
1. When a Monaural VCR is used, connect the Monaural Audio cable to the Audio "[:' (left) terminal.
2. Select the desired AV input position by pressing the "TV/A V" button (refer to page 6).
3. The AV3 audio input terminals serves as the audio input terminal for both the video input and for the DVD
input.
4. Input AV2 is located on the front of the unit.
.How to c:onnect the DVD Input Terminals ",,;
~
~
Notes:
1. The AV3 audio signal is common for both AV3 and DVD input signal terminals.
2. The DVD signal input terminal takes priority over the AV3 video signal input terminal.
.How to connect the A V Monitor Output Terminals to other Equipment
The "Monitor our terminal output the same signals as main picture on the TV screen and sound from the
speaker at that time, e.g. TV programmes or signals from AV1, AV2 or AV3 input.
Recording Equipment (VHS VCR)
~~~ ~ I
e !)()
~::::::::====~"'--
~
~
,~ 0 VIDEO
,d~ 0 Ll
"==~=~ 0 ~
IVIDEO
"""'"
Notes:
1. Never connect the same video recorder with both the VIDEO IN and MONITOR OUT terminals on this TV set,
as this could cause incorrect operation.
2. The MONITOR OUT emits the main picture normal video and audio signals.
3. The DVD signal (Y.PaoPR) is not output at the MONITOR OUT terminals.
~
4
-(4
-t
-t-
t-