Service Replacement
(On / Off)
Set to On to display a message to switch to the available service (only
available in some countries).
Watching > Tuning and editing channels > Other settings
●
For DVB-C, DVB-T
Signal Condition
Checks the signal condition.
Watching > Tuning and editing channels > Signal Condition
●
Not valid in Analogue
Antenna System
(One LNB / MiniDiSEqC / DiSEqC 1.0 / Single Cable)
Sets the antenna system to use plural LNBs for receiving several satellites.
Watching > Tuning and editing channels > Auto Setup
●
For DVB-S
LNB Configuration
Selects the satellite for each LNB.
Watching > Tuning and editing channels > Auto Setup
●
For DVB-S
Attenuator
(On / Off)
Automatically reduces the DVB-C signal to avoid the interference.
Watching > Tuning and editing channels > Other settings
Add TV Signal
Adds the TV mode.
Watching > Tuning and editing channels > Other settings
- 262 -
To Next Page
Loading...
