8
3D Eyewear
Note
• Use Panasonic 3D Eyewear supporting passive 3D system technology.
• Touch Pad Controller uses Bluetooth wireless technology.
• Design and Specifications are subject to change without notice. Mass and Dimensions shown are approximate.
• For the information of the open source software, refer to [eHELP] (Support > Licence).
• This equipment complies with the EMC standards listed below.
EN55013, EN61000-3-2, EN61000-3-3, EN55020, EN55022, EN55024
Receiving systems / Band name (E)
Check the latest information on the available services at the following website. (English only)
http://panasonic.net/viera/support
DVB-C Digital cable services (MPEG2 and MPEG4-AVC(H.264))
DVB-T / T2 Digital terrestrial services (MPEG2 and MPEG4-AVC(H.264))
PAL B, G, H, I, SECAM B, G, SECAM L, L’
VHF E2 - E12
CATV (S01 - S05)
VHF H1 - H2 (ITALY)
CATV S1 - S10 (M1 - M10)
VHF A - H (ITALY)
CATV S11 - S20 (U1 - U10)
UHF E21 - E69
CATV S21 - S41 (Hyperband)
PAL D, K, SECAM D, K VHF R1 - R2
VHF R6 - R12
VHF R3 - R5
UHF E21 - E69
PAL 525/60 Playback of NTSC tape from some PAL Video recorders (VCR)
M.NTSC Playback from M.NTSC Video recorders (VCR)
NTSC (AV input only) Playback from NTSC Video recorders (VCR)
Aerial input
(UK) UHF
(Ireland) / E VHF / UHF
Operating Conditions
Temperature: 0 °C - 35 °C
Humidity: 20 % - 80 % RH (non-condensing)
Built-in wireless LAN
Standard compliance and Frequency range*
1
IEEE802.11a/n 5.180 GHz - 5.320 GHz, 5.500 GHz - 5.580 GHz, 5.660 GHz - 5.700 GHz
IEEE802.11b/g/n 2.412 GHz - 2.472 GHz
Security WPA2-PSK (TKIP/AES), WPA-PSK (TKIP/AES), WEP (64 bit/128 bit)
Bluetooth wireless technology*
2
Standard Compliance Bluetooth 3.0
Frequency Range 2.402 GHz - 2.480 GHz
*
1
: The frequency and channel differ depending on the country.
*
2
: Not all the Bluetooth compatible devices are available with this TV. Up to 5 devices can be used simultaneously
(except Touch Pad Controller).
Dimensions (W H D) 165 mm 38 mm 166 mm
Mass Approx. 18 g
Usage temperature range 0 °C - 40 °C
Materials
Main body / Lens section Resin
To Next Page