- 48 -
■ Edit DVB / Analogue Channels
●
To swap / move the channel position (if available)
1) Press
(green) to edit
2) Set the new position with
/ or numeric buttons, and press
(green) to store
●
To retune each channel (Manual Tuning)
(red)
– For Analogue mode
Watching Tuning and editing channels Manual Tuning
– Only for the revealed channels
●
To rename the channel name (Analogue)
1) Press
(blue) to edit
2) Enter characters (maximum 5 characters) with
/ / / or
numeric buttons, and press OK to set
3) Press BACK/RETURN to store
= Note =
●
If a VCR is connected only with the RF cable in Analogue mode, edit VCR.
Auto Setup
Automatically retunes the channels received in the area.
●
This function is available if channel tuning is already performed.
●
Only the selected mode is retuned. All the previous tuning settings are
erased.
●
If Child Lock PIN number has been set, the PIN number is required.
Functions Child Lock PIN number
●
If tuning has not been done completely, set Manual Tuning.
Watching Tuning and editing channels Manual Tuning
■ DVB-C, DVB-T, Analogue channels
1. Select Auto Setup with / and press OK to access
2. Set DVB-C Auto Setup Settings with
/ / / and press OK to store
To Next Page