E
NGLISH
5
Remove the 3D Eyewear before moving around to
avoid falling or accidental injury.
Use the 3D Eyewear only for the intended purpose
and nothing else.
Do not use if the 3D Eyewear is physically
damaged.
Stop using the 3D Eyewear immediately if a
malfunction or fault occurs.
Stop using the 3D Eyewear immediately if you
experience any redness, pain, or skin irritation
around the nose or temples.
In rare cases, the materials used in the 3D Eyewear
may cause an allergic reaction.
Using Precautions
Do not drop or bend the 3D Eyewear.
Do not apply pressure to or scratch the surface of
the liquid crystal shutter of the 3D Eyewear.
Do not use devices (such as mobile phones
or personal transceivers) that emit strong
electromagnetic waves near the 3D Eyewear as this
may cause the 3D Eyewear to malfunction.
Do not use 3D Eyewear outside the specifi ed usage
temperature range (
page 14).
If the room is lit by fl uorescent lights (50 Hz) and
light appears to fl icker when using the 3D Eyewear,
switch off the fl uorescent light.
3D content will not be correctly visible if the
3D Eyewear is worn upside down or back-to-front.
Do not wear the 3D Eyewear when watching
anything other than 3D images. Other kinds of
displays (such as computer screens, digital clocks,
or calculators etc.) may be diffi cult to see while
wearing the 3D Eyewear.
Using radio waves
This unit uses the 2.4 GHz radio frequency
ISM band (Bluetooth
®
). However other wireless
equipment may use the same frequency. Be sure
to take note of the following to prevent radio wave
interference from other equipment.
● Restriction of use
For use only in your country.
(continued overleaf)
To Next Page
Loading...
