To Next PageTo Next Page
Need help?Do you have a question about the Panasonic TY-EW3D10E and is the answer not in the manual?
General| Battery type | CR2032 |
|---|---|
| Power requirements | DC 3V |
| On/off switch | Yes |
| Product color | Black, Silver |
Weight and Dimensions| Weight | 63 g |
|---|---|
| Dimensions (WxDxH) | 177 x 174 x 46 mm |
Product contains small parts. Keep out of reach of small children to avoid accidental ingestion.
Do not drop, exert pressure, or step on eyewear. Store properly; be careful of frame tips and hinges.
Batteries must not be exposed to excessive heat such as sunshine or fire.
Do not use if over-sensitive to light or have medical conditions. Stop if discomfort occurs.
Maintain correct viewing distance and keep eyewear horizontal to the screen to avoid accidents.
Correct eyesight problems before use, especially if experiencing double images.
Not for children under 5-6 years. Full supervision by parents or guardians is required.
Use only for intended purpose. Stop if malfunction, pain, or skin irritation occurs.
Danger of explosion if battery is incorrectly replaced. Use only equivalent types.
Do not drop, bend, scratch, or apply pressure. Avoid soiling the infra-red receiver.
Do not use devices emitting strong electromagnetic waves near eyewear to prevent malfunction.
Do not use outside temperature range. Switch off flickering fluorescent lights.
Receives TV signals for shutter control. Auto power off after 5 minutes without signal.
Controls 3D images by alternately opening/closing shutters for left/right eye views.
Details power button operation and indicator lamp signals for status and low battery.
Remove the insulating sheet from the battery compartment before the initial use.
Secure the eyewear by attaching the specialised band to the frame tips if it slips.
How to attach nose pads A or B for adjusting the eyewear's fit and comfort.
Configure TV menu settings, such as '3D Picture Display', to enable 3D image viewing.
Steps to turn on, wear, and adjust the 3D Eyewear for optimal viewing.
Turn off the 3D Eyewear after use and store it in the provided case.
Clean with a soft, dry cloth only. Avoid liquids, solvents, or abrasive materials.
Step-by-step instructions for replacing the coin-shaped lithium battery (CR2032).
Use specified CR2032 battery and insert with correct polarity. Ensure screw is tightened.
Check TV settings, infra-red signal path, and eyesight for issues with 3D image display.
Verify no blockage of infra-red signal and check battery level if power turns off by itself.
Indicator lamp off means battery is flat. Replace the battery with a new one.
Specifies lens type as Liquid Crystal Shutter and battery (CR2032) with duration.
Lists dimensions (width, height, length) and power supply (DC 3V).
Specifies transmitter range (3.2m, ±35°H, ±20°V) and operating temperature (0-40°C).
Do not mix with general waste. Dispose in designated national electronic collection schemes.
Contact dealer or local authorities for correct disposal methods outside general household waste.
