8 - ENGLISH
Viewing 3D Images
NOTE
• Charge the 3D Eyewear before using the rst time after purchase or after long
periods of disuse.
Using the television menu controls, set so that 3D images are
shown.
1. (When 3D image signals are being received) press the MENU button on
the television remote control.
2. Select “Setup”, and press the OK button.
3. Select “3D settings”, and press the OK button.
4. Select “Picture Display”, and use
to select “3D” or “2D”.
The procedure above is only an example. For details, see the television operating
instructions.
Wearing the 3D Eyewear
1. Set the power switch to “ON”.
(The indicator lamp will light for approximately 2 seconds, then ash
once approximately every 2 seconds.)
2. Put on the 3D Eyewear.
If the 3D images are not displayed correctly, adjust the 3D image-related settings.
For details, see the television operating instructions.
* The perceived three dimensional effects of the 3D Eyewear differ from person to
person.
NOTE
• If the eyewear stops receiving infra-red signals from the television, the power
automatically switches off after 5 minutes. If that happens, set the power switch
to “OFF” then “ON” again.
• For television settings, see the television operating instructions.
After Use
Set the 3D Eyewear power switch to “OFF”.
(The 3D Eyewear indicator lamp turns off, and the power turns off.)
After using the 3D Eyewear, store it in the case provided.
To Next Page
Loading...
