44
etwork ettings
This is a setting for connecting to a broadband environment.
Display the menu
Select "Setup"
Select "Network settings"
[] Press to exit from
a menu screen
EXiT
[] Press to return
to the previous
screen
RETURN
Select the settings and set
Check that the Network settings are as shown below, and then start "Connection test".
_1_Select "Connection test" and press OK _ Displayed Connection test screen
(it takes a while to cancel the test.)
_3_Complete Connection test
Success->Completion screen is displayed.
Error-->Follow the directions on screen to complete the setting.
If you perform the Proxy settings, check the Proxy address and
the Proxy port number.
Select Network type (Ethernet cable/Wireless (WiFi))
This setting is performed only when "Wireless (WiFi)" is selected in "Network connection" above.
Press "Wireless network", display screen
(only when "---", "No adapter" or "None" is displayed)
Set the following connection.
Please select the connection with your wireless LAN adapter and Access point.
_2_Follow the directions on screen to complete the setting
WPS(Wi-FiProtectedSetupusingpushbutton):
Wi-FiProtectedSetupisan easysettingoftheWi-FiAlliance'scertification.
YoucanconnecttheAccesspointto pressthe buttons.
WPS(Wi-FiProtectedSetupusingPINnumber):
Set thePIN codethat isdisplayedontheTV on theAccesspoint.
WPS(Wi-FiProtectedSetupusingpushbutton) (FormoredetailsonsettingofAccesspoint,pleasereferto operating
manualfortheAccesspoint.)
Searchfor wirelessnetworks:
SelectanAccesspointfromtheonessearchedfor automatically,and
configurethe settingsas instructedon thescreen.
Manualsettings:
ManuallysetSSID,Securitytype,andEncryptiontypeto matchthe
settingsoftheAccesspointto whichto connect.
* Whenconnectingby 11n(5 GHz),select"AES"astheEncryptiontype
for thewirelessLAN.
[] Displayed Connection status with an Access point
- - - : Connect with LAN cable
No adapter: Wireless LAN adapter is not installed.
None: There are no settings to connect Access point.
Connecting...: Currently connected to Access point.
If"Connected" is not displayed after a while, set
the Access point connection settings again.
Connected: Complete connection.
[] Displayed "Current settings and status" screen
(only when "Connected" or "Connecting..." is displayed)
You can confirm the AP connection status.
(SSlD/Wireless type/Security type/Encryption type/Connection status/Signal strength)
_) Press "Wireless network" _2_When you change "Wireless network" ==>Press "No"
Follow the directions on screen to complete the setting.
(example)
You need to be "Connected" to use network devices.
Please set Access point settings to "Connected".
®
Z
cD
o
O3
cD
£C}
O_
_ The Network settings become effective when you close the menu and run "Connection test". 45
To Next Page
Loading...
