Care all
Cleaning
First, unplug the Power cord plug from the wall outlet.
The front of the display panel has been specially treated. Wipe the panel surface gently using only a cleaning cloth or a soft, lint-
free cloth.
@ If the surface is particularly dirty, soak a soft, lint-free cloth in diluted mild liquid dish soap (1 part mild liquid dish soap diluted
by 100 times the amount of water) and then wring the cloth to remove excess liquid. Use this cloth to wipe the surface of the
display panel, then wipe it evenly with a dry cloth of the same type until the surface is dry.
@ Do not scratch or hit the surface of the panel with fingernails or other hard objects. Furthermore, avoid contact with volatile
substances such as insect sprays, solvents, and thinner; otherwise, the quality of the surface may be adversely affected.
If the cabinet becomes dirty, wipe it with a soft, dry cloth.
@ If the cabinet is particularly dirty, soak the cloth in a weak mild liquid dish soap and then wring the cloth dry.
Use this cloth to wipe the cabinet and then wipe it dry with a dry cloth.
@ Do not allow any mild liquid dish soap to come into direct contact with the surface of the Plasma TV.
If water droplets get inside the unit, operating problems may result.
@ Avoid contact with volatile substances such as insect sprays, solvents, and thinner; otherwise, the quality of the cabinet
surface may be adversely affected or the coating may peel off. Furthermore, do not leave it for long periods in contact with
articles made from rubber or PVC.
@ Cleaning
Wipe the surfaces with a soft, dry cloth. If the unit is particularly dirty, clean it using a cloth soaked with water to which a small
amount of mild liquid dish soap has been added and then wipe with a dry cloth.
Do not use products such as solvents, thinner, or household wax for cleaning, as they can damage the surface coating. (If
using a chemically-treated cloth, follow the instructions supplied with the cloth.)
@ Do not attach sticky tape or labels, as they can make the surface of the pedestal dirty. Do not allow long-term contact with
rubber, vinyl products, or the like. (Doing so will cause deterioration.)
Spec
cations
Rated Power
Consumption
On mode Average 99 W
Power Consumption*
_:: Standby condition 0.3 W
Drive method AC type
Aspect Ratio 16:9
Visible screen size 42 " class (41.6 inches measured diagonally)
(W_H xDiagona!)36.2 "x 20.4"x 41.6 "
921 mm x 518 mm x 1,057 mm)
N°_ °f p!xe! s) 2,073,600 (1,920 (w) x 1,080 (H))
[5,760 x 1,080 dots]
Audio Output 20 W [10 W + 10 W] (10 % THD)
VGA, SVGA, XGA, WXGA, SXGA
Horizontal scanning frequency 31 - 69 kHz
Vertical scanninq frequency 59 - 86 Hz
VHF/UHF: 2-69, CATV: 1-135
AC 120V, 60Hz
331 W 445 W
139 W
0.2 W
[[[;;;ii_
ililililililiiii_!_
[[[[i!i!ii!ili_
iiiiiiiiiiiilh
iiiiiiiiiiiiiiilh
50 " class (49.9 inches measured diagonally)
43.5 " x 24.4 " x 49.9 "
(1,105 mm x 622 mm x 1,268 mm)
Temperature: 32 °F - 104 °F (0 °C - 40 °C)
Humidity: 20 % - 80 % RH (non-condensinq)
VIDEO IN 1,2 VIDEO: RCA PIN Type x 1 1.0 V [p-p] (75 _)
AUDIO L-R: RCA PIN Type x 2 0.5 V [rms]
Y: 1.O V [p-p] (including synchronization)
COMPONENT. _+035v [p-p1
AUDIO L-R: RCA PIN Type x 2 0.5 V [rms]
TYPE A Connector x 3
HDMI 1,3 . This TV supports "HDAVl Control 5" function.
USB 1-2 _-
PC HD, VD / 1.O - 5.0 V [p-p] (high impedance)
LAN
for VlERA CAST IPTV] RJ45 (10BASE-T/100BASE-TX)
Card slot SD CARD slot x 1
DIGITAL AUDIO OUT PCM / Dolby Digital, Fiber Optic
3D Y/C FILTER CLOSED CAPTION
V-Chip IPTV (VIERA CAST)
VlERA IMAGE VIEWER Media player HDAVl Control 5
" x 27.3 " x 12.2 " 48.0 " x 31.9 " x 13.2 "
406
(1,'029 minx 693 mmx 308 mm (1,218 mmx 808 minx 335 mm)
406 " x 25.8 " x 3.5 " 48.0 " x 30.3 " x 3.5 "
(1,'029 mmx 654 mmx 88 mm) (1,218 mmx 769 mmx 88 mm)
Including pedestal 51.9 Ib (23.5 kg) 64.0 Ib (29.0 kg)
TV Set 0nly 45.2 Ib (20.5 kg) 57.4 Ib (26.0 kg)
[TC=P42GT25] [TC=P50GT25]
48.0 "(1,218 mm)3.5 " (88 mm) 3.5 " (88 mm)
15.7" 17.5"
(397 mm) 12.2" (308 mm) (443 mm) 13.2 "(335 mm)
@
©
_@
_rj)
_-z:3
___._"
@Design and Specifications are subject to change without notice. Mass and Dimensions shown are approximate.
64 * Based on IEC 62087 Ed.2 section 11.6.1 measurement method. 65
To Next Page
Loading...
