8
Accessories/OptionalAccessories
d Check you have all the items shown.
[] Remote Control
Transmitter
® N2QAYB000486
[] Operating Instructions
[] Batteries for the Remote
Control Transmitter (2)
® AA Battery
[] AC cord
[] Pedestal How to assemble
® TBLX0156 (TC-P42GT25) 9)
® TBLX0145
[] VIERA Concierge and Quick Start Guide
[] Product Registration Card (U.S.A.)
j
fOptional Accessories
3D Eyewear
(Battery operated type) (Rechargeable type available in autumn 2010)
® TY-EW3D10 ® TY-EW3D2S ® TY-EW3D2M ® TY-EW3D2L
Product information (Model No. and release date etc.) is subject to change without notice.
For more product information
(USA) http://www.panasonic.com (Canada) http://panasonic.ca
(Global reference) http://panasonic.net/avc/viera/3d/
Wall-hanging bracket Pleasecontact your nearest Panasonicdealer to purchasethe recommendedwall-hanging
(angled) bracket. For additionaldetails,please refer tothe wall-hanging bracketinstallationmanual.
@ TY-WK4P1RW Rear of the T _ fixing the TV onto the wall-hanging bracket
t_. (not supplied with the TV)
a: 15.7" (400 mm)
b: 11.8" (300 mm)
Holes for wall-hanging (View from the side)
bracket installation _
® in order to maintain the TV's performance and safety, be absolutely sure to ask your dealer or a licensed
contractor to secure the wall-hanging brackets.
® Carefullyreadthe instructionsaccompanyingoptionalaccessories,andbe absolutelysuretotake stepsto preventtheTV fromtippingover.
® Handle the TV carefully during installation since subjecting it to impact or other forces may cause product damage.
@ Takecare whenfixingwallbracketstothe wall.Alwaysensurethatthereareno electricalcablesorpipesinthe wallbefore hangingbracket.
® When using the angled-type wall hanging bracket, please ensure that there is sufficient space for the connecting
cables not to press against the wall when the TV is tilted forward.
For safety reasons, remove units no longer being used from their wall-mounted locations.
%
ull open
Hook Note the correct
polarity (+ or -).
Close
Caution )
® Incorrect installation may cause battery
leakage and corrosion, resulting in
damage to the remote control.
,_,Do not mix old and new batteries.
** Donotmix differentbatterytypes
(suchasalkalineandmanganesebatteries).
_ Do not userechargeable(Ni-Cd)batteries.
® Do not burn or break batteries.
reAssembling the pedestal
® Fix securely with assembly screws {A}. (Total 3 screws)
® Tighten screws firmly,
Pole
Front
/
reSet-up
@ Carry out work on a horizontal and level surface.
® Tighten assembly screws (B"_(total 4 screws) loosely at first,
then tighten them firmly to fix securely.
Bottom view
Rear side
_edestal
installation
Accessories
Assembly screws
_Y
NYN5+F18FN
M5 x 18 (Silver) (3)
THEL0g0N (for 42")
THEL079N (for 50")
M5 x 30 (Black) (4)
Pole (1)
Base (1)
Pole
Base
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall hanging bracket or repacking the TV.
Remove the assembly screws _B_from the TV.
Pull out the TV from the pedestal.
Remove the assembly screws _A} from the pole.
Do not disassemble or modify the pedestal.
® Otherwise the TV may fall over and become damaged, and personal injury may result.
{ Caution
Do not use any other TV and displays.
@Otherwise the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
® If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic
Dealer immediately.
During set-up, make sure that all screws are securely tightened.
® If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
When removing the pedesta!, do not remove the pedestal by any methods other than the specified procedure. (see above)
® Otherwise the TV and/or pedestal may fall over and become damaged, and personal injury may result.
®
>
o
o
O0
o
GO
O
o
>
o
o
©
U_
9