To Next PageTo Next PageWhy does my Panasonic Heat Pump system switch off automatically?
If the Panasonic Heat Pump system operation switches off, it's due to the system's protection control. This happens when the water inlet temperature falls below 10 °C, causing the compressor to stop and the backup heater to activate.
What to do if Panasonic WH-MDC05J3E5 system does not work?
If your Panasonic Heat Pump system isn't working, check if the circuit breaker has tripped or activated.
How to improve the efficiency of Panasonic WH-MDC05J3E5 in HEAT/COOL mode?
If your Panasonic Heat Pump is not operating efficiently in HEAT or COOL mode, ensure the temperature is set correctly. Also, close the panel heater/cooler valve and clear any obstructions in the air inlet and outlet vents of the mono bloc unit.
Why is my Panasonic Heat Pump so noisy?
If your Panasonic Heat Pump is making excessive noise during operation, it could be due to the mono bloc unit being installed at an incline, or the cover not being closed properly. Ensure the unit is level and the cover is securely closed.
What to do if the operation LED is not lit on my Panasonic WH-MDC05J3E5 Heat Pump?
If the operation LED is not lit, or nothing is displayed on the Panasonic Heat Pump Remote Controller, check that the power supply is working correctly, or if a power failure has occurred.
General| Heating Capacity | 5.00 kW |
|---|---|
| COP | 4.74 |
| Refrigerant | R32 |
| Weight (Indoor Unit) | 10 kg |
| Type | Air-to-Water Heat Pump |
| Cooling Capacity | 5.0 kW |
| Power Supply | 230 V |
