To Next PageTo Next PageWhy is my Panasonic WH-MDC09H3E5 Heat Pump system hard to heat up?
Your Panasonic Heat Pump system may be taking longer to heat up because the panel and floor are being heated simultaneously, which can lower the water temperature and reduce heating ability. Also, low outdoor air temperatures, blockages in the discharge or intake of the mono bloc unit (like snow), or a low preset water outlet temperature can cause this issue.
Why is my Panasonic WH-MDC09H3E5 system not heating up instantly?
If your Panasonic Heat Pump starts operating with cold water, it will take some time to heat the water, so immediate heating is not expected.
How to improve HEAT/COOL mode efficiency on a Panasonic WH-MDC09H3E5?
To improve the efficiency of your Panasonic Heat Pump's HEAT/COOL mode, set the temperature correctly, close the panel heater/cooler valve, and clear any obstructions in the air inlet and outlet vents of the mono bloc unit.
Why is COOL mode unavailable on my Panasonic WH-MDC09H3E5?
The COOL mode on your Panasonic Heat Pump might be unavailable because the system is locked to operate only in HEAT mode.
Why does my Panasonic WH-MDC09H3E5 operation start automatically?
If your Panasonic Heat Pump starts operating automatically even when the timer isn't set, check if the sterilization timer has been activated.
Why is the backup heater turning on automatically on my Panasonic WH-MDC09H3E5?
The backup heater in your Panasonic Heat Pump might automatically turn on, even when disabled, due to the protection control of the unit's heat exchanger.
Why does my Panasonic WH-MDC09H3E5 make loud refrigerant noises?
The loud refrigerant noise in your Panasonic Heat Pump is caused by protection control during de-icing when the outdoor temperature is below -10 °C.
Why does my Panasonic Heat Pump mono bloc unit emit water or steam?
The emission of water or steam from your Panasonic Heat Pump mono bloc unit is due to condensation or evaporation occurring in the pipes.
Why does steam come out of my Panasonic WH-MDC09H3E5?
Steam coming from the Panasonic Heat Pump mono bloc unit during heating mode is due to the defrost operation in the heat exchanger.
Why does my Panasonic WH-MDC09H3E5 make a water flowing sound?
The water flowing sound you hear during the operation of your Panasonic Heat Pump is due to the refrigerant flow inside the unit.
General| Model | WH-MDC09H3E5 |
|---|---|
| Category | Heat Pump |
| Heating Capacity | 9.0 kW |
| Refrigerant | R32 |
| Type | Air to Water |
| Power Supply | 230 V |
