Why is my Panasonic WH-SDC12K6E5 so noisy?
If the Panasonic Heat Pump is noisy during operation, it might be due to the outdoor or indoor unit being installed at an incline. Ensure the units are level. Also, make sure the cover is properly closed.
How to improve HEAT/COOL mode efficiency in Panasonic WH-SDC12K6E5?
If your Panasonic Heat Pump system is not working efficiently in HEAT/*1, *2 COOL mode, make sure you've set the temperature correctly. Also, close the panel heater/cooler valve and clear any obstructions in the air inlet and air outlet vents of the outdoor unit.
Why is COOL mode unavailable on my Panasonic WH-SDC12K6E5?
The system has locked to operate in HEAT mode only.
Why doesn't my Panasonic WH-SDC12K6E5 Heat Pump heat up instantly?
The system will take some time to heat up the water if it starts to operate at cold water temperature.
Why is my Panasonic Heat Pump system hard to heat up?
If your Panasonic Heat Pump is hard to heat up, it may be due to several reasons. When the panel and the floor are heated simultaneously, warm water temperature may decrease, which may reduce the heating ability of the system. When the outdoor air temperature is low, the system may need longer time to heat up. Check if the discharge outlet or intake inlet in the outdoor unit is blocked by some obstacle, such as a pile of snow. When the preset water outlet temperature is low, the system may need longer time to heat up.
Why doesn't the outdoor unit of my Panasonic Heat Pump operate?
The outdoor unit of your Panasonic Heat Pump may not operate due to the protection control of the system when the outdoor temperature is out of the operating range.
Why does the backup heater turn on automatically on my Panasonic WH-SDC12K6E5?
If the backup heater is automatically turned ON when it is disabled on your Panasonic Heat Pump, it is caused by the protection control of the indoor unit heat exchanger.
Why does my Panasonic Heat Pump start automatically?
If the Panasonic Heat Pump operation starts automatically when the timer is not set, it means the sterilization timer has been set.
Why is my Panasonic WH-SDC12K6E5 making a loud noise?
The loud refrigerant noise that continues for several minutes is caused by protection control during deice operation at outdoor ambient temperature lower than -10 °C.
What to do if my Panasonic Heat Pump operation in HEAT/COOL mode is not working efficiently?
If your Panasonic Heat Pump isn't heating or cooling efficiently, make sure you set the temperature correctly, close the panel heater/cooler valve, and clear any obstructions in the air inlet and air outlet vents of the outdoor unit.
To Next Page
General