Why does the power consumption display on my Panasonic Heat Pump remain at the previous value?
The display power consumption remains as the previous value because the memory is saved on an hourly basis. If a power failure occurs, the data kept from the last hour will be displayed. Also, if the total power consumption has reached 999 days, you may need to reset the counter.
Why is there a delay after restarting my Panasonic WH-UX12FE5?
The delay is a protection mechanism for the compressor.
What causes the water flowing sound during Panasonic WH-UX12FE5 operation?
The water flowing sound during operation is due to refrigerant flow inside the unit.
Why does my Panasonic WH-UX12FE5 outdoor unit emit water or steam?
The emission of water or steam from the outdoor unit is due to condensation or evaporation occurring in the pipes.
Why does my Panasonic Heat Pump make a loud refrigerant noise for a few minutes?
The loud refrigerant noise is caused by protection control during deice operation when the outdoor ambient temperature is lower than -10°C.
What does it mean when the HEAT indicator blinks on the display of my Panasonic WH-UX12FE5 Heat Pump?
A blinking HEAT indicator means the system is performing a deice operation.
Why does steam come out of the outdoor unit of my Panasonic Heat Pump in heating mode?
The steam is caused by the defrost operation in the heat exchanger.
Why does my Panasonic WH-UX12FE5 Heat Pump operation start automatically when the timer is not set?
Automatic operation without a timer setting indicates that the sterilisation timer has been set.
Why is the backup heater automatically turned ON in my Panasonic WH-UX12FE5 Heat Pump when it is disabled?
The backup heater may turn on automatically due to the protection control of the indoor unit heat exchanger.
Why is my Panasonic Heat Pump system hard to heat up?
Your Panasonic Heat Pump system may be hard to heat up because: 1. The panel and floor are being heated simultaneously, which can decrease warm water temperature. 2. The outdoor air temperature is low, increasing the time needed to heat up. 3. The discharge or intake of the outdoor unit is blocked by an obstacle like snow. 4. The preset water outlet temperature is set too low.
Explains warning signs, caution symbols, and prohibited/compulsory actions for safe operation.
Covers safety for children, authorized personnel, and handling the unit during operation.
Details on using power cords, preventing overheating, and checking residual current devices.
Safety instructions for indoor/outdoor units, including washing, placement, and sharp parts.
Configures the capacity rank to match indoor and outdoor units for optimal system performance.
Lists common symptoms that do not indicate malfunction and their probable causes.
Lists diagnostic codes, their corresponding abnormalities, and protection control actions.
General| Cooling Capacity | 3.5 kW |
|---|---|
| Heating Capacity | 4.0 kW |
| Power Supply | 3 Phase, 380-415V, 50Hz |
| Refrigerant | R32 |
| Nominal Heating Capacity | 4.0 kW |
| Nominal Cooling Capacity | 3.5 kW |
| Operating Temperature Range (Heating) | -15°C to 24°C |
| Type | Split |
To Next Page
