16
2. Disassembling Procedure
8
Referring to Fig. 2-1, remove three knobs and fifteen
screws that secure the Upper Cover Ass'y.
Fig. 2-1
8
Referring to Fig. 2-2, pull up the Upper Cover Ass'y and
hock to the slot of the Right Side Chassis of the Upper
Cover Ass'y.
Fig. 2-2
8
Referring to Fig. 2-3, pull up the Upper Cover Ass'y and
remove nine screws that secure the HA Block and remove
the HA Block.
8
Cut one Wire Binder that secure the Ground Cable and
others.
8
Remove one screw that secure the Ground Cable (Brown
Wire) at the Power-2 Board and tighten this screw.
8
Connect this Ground Cable (Brown Cable) to the Chassis.
Fig. 2-3
8
Referring to Fig. 2-4, disconnect three Cables from the
Connectors CN33, CN52 and CN 53 of the AD/DA Board.
8
Insert two Cables from the Power-2 Board to the AD
EXTD-1.
8
Insert two Cables of the AD EXTD to two Connectors
CN52 and CN53 of the AD/DA Board.
8
Insert the AD EXTD-2 between CN33 of the Main Board
and CN33 on the AD/DA Board.
Fig. 2-4
To Next Page
Loading...
