10
11
12
13
14
15
Camera Input Connectors (CAMERA INPUT)
The BNC type connectors are used to accept the coaxial
cables from the specified cameras.
These connectors supply the DC power and vertical drive
pulse.to
the cameras, and receive the video signal from
the cameras.
Note:
l Be sure to connect only the specified cameras.
l Connect the camera after making sure that the monitor
is off.
If the camera is connected while the monitor is on,
the camera will not be functioned by activating the
protection circuit for
misconnection.
Video Output Connector (VIDEO OUT)
The BNC type connector is used to provide the video
output signal of the camera for the
additional,monitor
or video tape recorder.
The video output signal of the camera is provided at this
connector even if the Mode Selection Switch (2) is set to
the STANDBY position,
Video‘lnput Connector (VIDEO IN)
This is an video input connector from a
VTR
for observing
the playback picture.
When the
KfR
playback picture is to be shown on the
video monitor, set the Input Selection Switch (3) to the
EXT position and Mode Selection Switch (2) to the ON
position.
Timing Output Connector (TIMING OUT)
This output connector provides the timing pulse signals
for switching in the sequence operation for other system
such as another Mini CCTV System or sequential switcher.
Power Cord
Timing Selection Switch (TIMING SELECT
INT/EXT)
The timing pulses for the sequential switching interval can
be selected as;
INT:
The timing pulses for the sequential switching interval
are generated in the video monitor
WV-BMSO.
EXT:
The timing pulse for the sequential switching interval
are synchronized with the external timing pulses fed to
the External Timing Input Connector (16) from the time
lapse
VTR
or another Mini
CClV
System.
16
17
18
19
20
21
1
External Timing Input Connector (EXT IN)
This is an input connector for the external
timing
from the time lapse
VTR
or another Mini CCTV Syst
Camera Extension Input Connector
-
.
(CAMERA EXTENSION IN)
This is a IO-pin connector for the Camera Extensi,
WV-63 for expanding the system up to 7 cameras
2
informations are as;
Pin 1:
Video Input Signal
Pin 2:
VD Output Signal
Pin 3:
Ground
Pin 4:
Logic Signal for Sequence
Pin 5:
Logic Signal for Sequence
Pin 6:
Logic Signal for Sequence
Pin 7:
Logic Signal for Sequence
Pin
0:
Logic Signal for Sequence
Pin 9:
Logic Signal for Sequence
Pin
IO:
Logic Signal for Sequence
Camera Extension Switch
(CAMERA EXTENSION, ON/OFF)
This selects the condition of camera extension
fc
as;
ON:
Camera pictures connected to the Camera Extl
Unit WV-63 can be observed on the monitor.
OFF:
Select this position whenever the Camera
Exh
Unit WV-63 is not connected.
Vertical Hold Control (V.HOLD)
Locks in the picture of the monitor vertically.
Auto Reset Switch (AUTO RESET, ON/OFF)
This selects the condition of auto reset function as,
ON:
The automatic reset function performs and the
matic
reset time is set to approx. 60 seconds
OFF:
The automatic reset function is disabled.
Alarm Time Adjustment (ALARM TIME ADJ)
The alarm time can be manually adjustable by turnir
control.
The alarm time can be set from 2 to 30 seconds
(1
se
step).
.
--_
_..I_
-3-
To Next Page
Loading...
