OPERATING PROCEDURE
SELECTION OF CAMERA
Note:
Set the Power Switch (POWER) on the front panel to the
ON position by pushing once.
The switch remains down
(
A
)
keeping the monitor and
camera ON, and green lamps for sequence and channel(s)
which the Camera(s) is/are connected light ON approx.
4 seconds for you to confirm how many cameras are
connected.
The sequential switching features the automatic by-
-
pass circuit by detecting the presence of the DC power
’
e
_
for the camera so that the input connector with no
camera connection is automatically skipped.
Push the Camera Selection Switch for selecting the de-
sired camera’s picture and green lamp lights.
Note:
1.
The desired camera’s picture can be seen on the mon-
itor by pushing the Camera Selection Switch at the
sequence mode.
2. also, the desired camera’s picture can be seen on the
monitor by pushing the Camera Selection Switch.
Caution:
l
1.
2.
3.
4.
5.
6.
7.
STANDBY MODE
-
MONITORING PICTURE
Set the Power Switch (POWER) on the front panel to the
ON position by pushing once.
When the power switch of monitor is turned ON and
OFF repeatedly in the short period of time, the camera
may not be turned ON due to the operation of
miscon-
nection
protection circuit.
In this case, leave the switch in the OFF position for a
few seconds before turning it ON again.
The switch remains down
(
a
)
keeping the monitor and
camera ON, and green lamps for sequence and channel(s)
which the Camera(s) is/are connected light ON approx.
4 seconds for you to confirm how many cameras are
connected.
SEQUENCE MODE (More than two cameras)
Set the Power Switch (POWER) on the front panel to the
ON position by pushing once.
The switch remains down
(
II
)
keeping the monitor and
camera ON, and green lamps for sequence and channel(s)
which the Camera(s) is/are connected light ON approx.
4 seconds for you to confirm how many cameras are
connected.
Set the Mode Selection Switch (MODE) to the ON position.
Push the Sequence Switch (SEQUENCE) to be sequential
switching and green lamp lights.
Adjust the Time Adjustment (TIME ADJ) to be desired se-
quential switching interval (from 1 to 30 seconds).
Set the Mode Selection Switch (MODE) to the ON position.
Push the Sequence Switch (SEQUENCE) to be sequential
switching.
Adjust the Time Adjustment (TIME ADJ) to be desired se-
quential switching interval (from
1
to 30 seconds).
Set the Mode Selection Switch (MODE) to the STANDBY
position. The picture on the monitor will disappear, how-
ever the sequential switching is actually being carried and
the picture can be observed on the additional monitor
connected to the Video Output Connector.
When the picture of the desired camera is ob-
served/monitored, push the button of Camera Selection
Switch for the desired camera and green lamp lights.
By pushing the Sequence Switch (SEQUENCE) again, the
picture on the monitor will disappear and back to the
sequential switching in the STANDBY mode.
PV”Ver
Mode
Input
Bright
contrast
Time
sequence
Camera Selection
Swtch
Select&
Selection
Control
Control
Adjustment Switch
Switches
Switch
Switch
I
~
Bypass Selection
Swtches
Green
Lamp
.
“-_
*.
*_
-5-
To Next Page
Loading...
