Panasonic WV-CP300

25
Screenshot 3
The selected setup screen in the setup menu
appears on the screen.
**CAMERA SETUP**
SCENE1
ALC/ELC ALC
SHUTTER OFF
AGC ON(HIGH)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
D&R(IR) AUTO1
VMD
OFF
RET TOP END
Note:
 • If the top screen of the setup menu is
called up with the operation buttons
while the camera is operated, the setup
mode is always "DISABLE" to prevent
operation errors.
  To perform settings in the setup menu,
changethesetupmodeto"ENABLE".
 • Thecursorisareverselyhighlightedpart.
Step 4
Performthesettingsforeachitem.
•
Selection of setting item:
Pressthe[UP]buttonor[DOWN]buttonto
movethecursor.
• Change of settings:
Pressthe[RIGHT]buttonor[LEFT]button.
• Display of advanced setup screen:
Press the [SET] button when " " is
attachedtothetargetsettingitem.
• Return to previous setup screen:
Move the cursor to "RET" and press the
[SET]button.
• Return to the top screen:
Move the cursor to "TOP" and press the
[SET] button, to display the top screen of
the setup menu.
Step 5
Movethecursorto“END”andpressthe[SET]
buttontoreturntothecameraimagescreen,
or wait about 5 minutes and the setup menu
will automatically close.
PGQX1142YA_WV-CP300_G.indd 25 2012/4/2 14:11:03