Panasonic WV-CP410

(10) AGC ON/OFF Switch (AGC, ON/OFF)
This switch is used to select the gain of the video
amplifier as follows.
ON: When the liens iris is fully opened under a low
light condition, a clear picture is obtained by
automatic increase of the gain.
OFF: A natural and low-noise picture is obtained
under a low light condition.
(11) Electronic Light Control/Automatic Light
Control Selection Switch (ELC / ALC)
This switch is used to select the light control func-
tion, depending on lens type, as follows.
ALC: Choose this position when using an auto iris
lens.
ELC: Choose this position when using a fixed or
manual iris lens.
(12) Detail level Selection Switch (SOFT/SHARP)
The detail/aperture level can be selected by this
switch.
Set the switch to the desired position while observ-
ing the picture on the monitor.
Note: Usually set this switch to the SHARP posi-
tion. When a Quad System is connected to
this camera, set this switch to the SOFT posi-
tion.
(13) Backlight Compensaiion On/Off Switch
(BLC ON/OFF)
When backlight affects the picture, set this switch
to the “BLC ON” position for a clear picture.
(14) Lens Selection Switch (VIDEO/DC)
This switch is used to select the type of auto. iris
control signal to be supplied to the lens from the
Auto Iris Lens Connector.
DC: Choose this position when an auto iris lens
that requires a DC control signal is mounted
on the camera. See pages 12, 13, 14, 15 and
16 for a list of these lenses.
VIDEO: Choose this position when an auto iris lens
that requires a video control signal is mounted
in the camera.
Examples of this type of lens includes WV-LA8B,
WV-LA16B, WV-LA25B and the WV-LASOB,
(15) Automatic Tracing White Balance Control
ON/OFF Switch (ATW, ON/OFF)
The white balance setting function can be select-
ed as follows: