Special 1 menu
26
■ Patrol Learn and Patrol Play
(PATROL)
A routine of manual operations can be stored for 30 seconds at the
maximum and reproduced repetitively.
1. Set the following parameters for the patrol learn starting position.
These parameters are stored when the patrol learn mode starts.
• PAN/TILT/ZOOM/FOCUS
• IRIS
• SHUTTER
• AGC
• WHITE BALANCE
• IMAGE HOLD
• CAMERA ID
• PAN LIMIT
• CLEANING
After starting the patrol learn, the following manual operations are
stored.
• PAN/TILT/ZOOM/FOCUS operation
• IRIS operation
• Preset positioning
2. Open the SET UP menu and move the cursor to PATROL. Select
LEARN, PLAY or STOP for PATROL by moving the joystick to the
right or left.
The factory default setting is STOP.
LEARN: A series of manual operations is stored.
PLAY: Stored operations are reproduced.
STOP: LEARN or PLAY is not activated.
Patrol Learn with a Controller Having the PATROL Key
1. Press the PATROL LEARN key and the PROGRAM key simultane-
ously to start the patrol learn. The setup menu changes to show
“LEARNING” and the starting points are stored.
2. Operate the patrol learn manually. The operation data is stored.
3. To stop the patrol learn, press the PATROL STOP key and the
PROGRAM key simultaneously.
To Next Page
Loading...
