41
X ON/X OFF (X ON/X OFF)
Specifies whether to apply flow control or not (NOT USE, USE). The factory setting is NOT USE.
Wait Time (WAIT TIME)
Specifies the time to wait until retrying after confirming that no data is received from the controller.
(OFF: no retry, 100, 200, 400, 1 000 ms).
The factory setting is OFF.
Delay Time (DELAY TIME)
Specifies the time to transmit the acknowledge request when communicating on a 2-line connection.
[----,100 ms] Default: ---- (no set).
This menu appears only when a 2-line communication is used. Make sure to be 100 ms when connecting
the camera with the WJ-FS616 Video Multiplexer or Matrix Switcher WJ-SX350 in a 2-line communication
system.
The settings become effective with the closing of the SET UP MENU.
Note: Set the same parameters for the cameras, controllers and personal computers in an RS485 chain.
To Next Page
Loading...
