Pandhora P3 - Coupling Thruster to Wheelchair

To Next Page

To Previous Page

Usar_Manual_Pandhora_P3_ENG_Rev.0_05/2020

4.3 Coupling the P3 Thruster To The Wheelchair.

 Make sure the thruster is turned off.

Place both the wheelchair and the thruster on a perfectly flat floor. WARNING! The thruster

and the wheelchair, if not placed on a perfectly flat floor during installation and coupling,

could move accidentally and cause damage to both the user and the device.

 Unlock the positioning piston and place the side arms parallel to the floor.

 Lock the parking brakes on the wheelchair, then move the thruster a few towards the

wheelchair.

 Couple the conical male couplings with the conical female couplings and tighten the

lateral clamping levers.