To Next PageTo Next Page
Need help?Do you have a question about the Panduit CJ6X88TG Series and is the answer not in the manual?
General| Series | CJ6X88TG |
|---|---|
| Category | Control Unit |
| Shielded/Unshielded | Unshielded |
| Color | Aqua |
| Material | Plastic |
Measuring the outer jacket to 2.00 inches (50.8mm) for preparation.
Using CWST to cut the cable jacket without damaging inner wires.
Trimming the wires to 0.50 inches (12.7mm) after jacket removal.
Preparing the wire pairs for subsequent termination steps.
Cutting the outer jacket and MaTriX tape using CJAST tool setting 9.
Applying MaTriX tape to the cable after cutting the outer jacket.
Using the CWST tool for cable preparation and jacket management.
Separating and preparing the individual wire pairs for termination.
Stripping insulation from conductors and trimming to 0.5-inch.
Arranging the prepared conductors according to wiring standards (T568A/B).
Inserting conductors into jack slots and terminating with a tool.
Terminating cables according to T568B and T568A wiring standards.
Completing the jack termination process using the EGJT tool.
Steps for safely disconnecting and removing the jack module.
Procedure for removing conductors from the jack termination.
Identifying wire colors (R, F, B, D) during removal.
