17
© Copyright 2008 Panoramic Corporation
PC-1000 Installation
Install Top and Rear Covers
1. Ensure that the RUN/STOP switch on the
printed circuit board in the overhead is in the
RUN position.
2. Slide the top cover on the machine from the
front. Ensure that the wiring on the control
panel side is properly routed.
3. Install the 6 screws on the underside of the top
cover.
4. Place the cover on the rear of the machine and
install the 3 screws.
Complete Installation
1. Verify all steps have been completed.
2. Refer to the PC-1000/Laser 1000 User Manual
and train the staff thoroughly.
3. Complete the Panoramic Corporation
Installation Report and the FDA 2579
paperwork and distribute accordingly.
To Next Page
Loading...