DIGITAL CLOCK WITH BLUETOOTH SPEAKER
PRODUCT OVERVIEW
MODELS: PT-BS006Y, PT-BS006N, PT-BS006P, PT-BS006L
Top View
1 2 3 4 5 6
Front View
7 8 9 10 11 12 13
Side View
14
15
16
1. (alarm 1) : press to turn alarm 1 on.
Press again to turn the alarm off. Press
and hold to set the clock/alarm.
2.
(alarm 2) : press to turn alarm 2 on.
Press again to turn the alarm off. Press
and hold to set the clock/alarm.
3.
(MODE) button : press to switch
between different input modes.
4.
: press to play the previous song.
5.
: press to play the next song.
6.
: press to play/pause song.
• Press and hold to turn the product on. Press and hold again to turn the product off.
• Press the button twice to turn the LED knob light on/off.
7 LED display
8.
(Alarm 1) : lights up when 1st alarm is set.
9.
(Alarm 2) : lights up when 2nd alarm is set.
10. BT indicator: lights up when connected to a Bluetooth device.
11. TF (Micro SD) indicator : lights up when a Micro SD card is
inserted into the TF card port.
12.
13. Volume control knob : rotate the knob clockwise to increase
volume. Rotate the knob anticlockwise to decrease volume.
14. TF Card/Micro SD card slot: insert your Micro SD card to play
the songs stored in your Micro SD card.
15. Charging LED indicator
16. USB-C port: use the supplied USB-C charging cable to charge the product.
OPERATION
Power on and charging
Before rst time use, charge the product using the supplied USB-C charging
cable. Plug the cable into the USB-C port on the product and the other end to
a power source. Charge for 2 hours.
Press and hold the button to turn the product on or off.
Press the button to enter 1st alarm. Press and hold the button again and the
hour number on the LED display will ash. Use the / buttons to set the hour.
Press the button again and the minutes number on the LED display will ash.
Use the / buttons to set the minutes. The Alarm light will light up indicating
alarm is on.
Press the button again to enter the ringtone selection. There are 5 ringtones to
choose from. Use the / buttons to select the desired ringtone.
Press and hold the button to save the settings of the 1st alarm.
For the 2nd alarm, repeat the steps above using the button.
When an alarm rings, press any button to stop/end the alarm.
To turn off an alarm, when on alarm mode, press the buttons.
Setting the time
Alarm settings
Press and hold the button to enter clock settings, the hours number will
ash on the LED display. Use the / buttons to set the hour.
Press the button again and the minutes number will ash on the LED
display. Use the / buttons to set the minutes.
Press and hold the button to nish setting the time.
To reset time settings, rst delete the alarm settings.
To Next Page
Need help?
General
