cod. 97843 / 97844 / 97846
23
Once the machine has been set up properly, start the engine as follow:
1.
Attention: When the brush cutter is used and started for the very first time, the final user is
warmly recommended to push the primer pump for 10 times at least, so has to obtain the best
performance of the equipment for future use as well.
2. Turn the engine switch to the ON position.
3. Put the choke lever on the A (OFF) position
4. Pull the recoil starter handle 3-5times to start the engine, as following picture.
It needs to be hold the throttle trigger when starting.
5. Adjust the choke lever to B (half open) position.
To Next Page
Loading...
