1
Line up the holes on the left and right rails with the designated holes located on the front leg and
back leg frames. From there, layer a spring washer onto a flat washer (B5, B6) before tightly
screwing the designated allen bolts (B1) in place with an allen key.
NOTE: Loosely hand thread all bolts into place to check alignment before proceeding. When all
pieces are properly aligned, securely tighten each bolt into place. If screws/bolts don’t thread in,
try to adjust by loosening the metal brackets.
3 / 7
Assembly Instructions
A3
A7
B1
B2
B6
B5
B7
A8
A4
To Next Page
Loading...