PIVOT ARMS
The Pivot Arms (5) can be adjusted to allow for a greater or lesser degree of inversion. To adjust
the Pivot Arms (5) simply pull out on them until the post is out of the hole, slide them up or down
to the desired hole, push in until the post goes through the desired hole, The bottom hole
provides the least amount of inversion, while the top hole provides the greatest amount. It is
recommended that beginners use the bottom hole until they are familiar with the inversion table.
NOTE: Both Pivot Arms (5) must be adjusted to the same hole. Trying to adjust the Pivot Arms (5)
on two different positions could cause damage to the inversion table, or injury to the user.
18
To Next Page
Loading...
