Paradigm 100 - Hardware Packing List

HARDWARE PACKING LIST
7
Part # Description Quantity
11 Hex Head Bolt M6*47 ------------------------------------------------------------------------------------------2
13 Washer Ø 20 *Ø 8.5 * 1.5 --------------------------------------------------------------------------------------8
15 Lock Nut M8 --------------------------------------------------------------------------------------------------------6
16 Lock Nut M6 --------------------------------------------------------------------------------------------------------2
27 Washer Ø 16 *Ø 6.5 * 1.0 --------------------------------------------------------------------------------------4
29 Pivot Arm Reinforcement Plate--------------------------------------------------------------------------- 2
38 Hex Head Bolt M8*17 ------------------------------------------------------------------------------------------2
40 Hex Head Bolt M8*50 ------------------------------------------------------------------------------------------2
43 Nut Cap Ø 27*Ø 13.5---------------------------------------------------------------------------------------------2
NOTE:  The parts described above are all the parts you need to assemble this inversion table.
Before you start to assemble, please check the hardware packing to make sure they are
included.
 All the other parts described in page 6 parts list are pre-assembled in the factory.
ASSEMBLY
Set all parts in a clear area on the floor and remove the packing materials. Refer to the part lists for help
to identify the parts. Follow the steps to assemble the inversion table.
Double open wrench M12*14 (2PCS)