For added safety, a nylon strap has been included to restrict the degree of inversion. This strap
can be adjusted to different lengths to allow for a greater or lesser degree of inversion. To
lengthen the Nylon Strap (32) feed the top end of Nylon Strap (32) into the strap lock, and pull on
the lower end of the strap. To shorten the length feed the bottom end of Nylon Strap (32) into the
strap lock, and pull on the top end. See Diagram.
ADJUSTING THE BOOM
The Adjustable Boom (3) can be moved to a variety of different positions, in order to
accommodate the height of the person on the inversion table. To adjust the boom loosen the
knob (30), pull out the Large Spring Knob (18), and slide the boom up or down until the desired
height on the Height Scale (44) is positioned just below the Square Bushing (26). When the boom
is in the desired position, simply release the Large Spring Knob (18), slide the boom slightly up or
down until the Large Spring Knob (18) locks into place, and tighten the Knob (30).
To Next Page
Loading...
