FOLDING THE INVERSION TABLE
For your storage convenience, the inversion table can be folded down to place against a wall,
under a bed, or in a storage area. To fold the inversion table pull out the Large Spring Knob (18)
and loosen Knob (30). Now, slide the Adjustable Boom (3) all the way up into the Bed Frame (4)
until the instep frame is just below the Bed Frame (4), release the Large Spring Knob (18) and slide
the Adjustable Boom (3) slightly up or down until the Large Spring Knob (18) locks the Adjustable
Boom (3) in place. Remove Lock Nuts (15), Washers (13) and Bolts (10) from both pivot arm
reinforcement plates and the top of the rear U-frame. Then remove the Bed Frame (4) from the
base by lifting up on the Bed Frame (4) until the Pivot Arms (5) come out of the arm slots located
at the top of the Rear U-frame (2), (make sure the strap is not attached to the bed frame before
attempting to remove it.) Install the Lock Nuts (15), Washers (13) and Bolts (10) onto the top of
the rear U-frame that were removed. Push up on the center of the Folding Arms (8) and push the
Front and Rear U-frames (1, 2) together until they meet. Now the inversion table is ready to be
stored, and you can till unfold it quickly and easily whenever you want to use it.
22
To Next Page
Loading...
