What to do if my Paradigm Founder 120H has no sound?
If your Paradigm Stereo System isn't producing any sound, ensure the receiver, preamp, or amplifier is plugged in and turned on. Verify that the power outlet is working. Also, check if headphones are plugged in or if the system is on mute. Finally, re-check all connections.
How to fix lack of bass or dislocated image on Paradigm Founder 120H Stereo System?
A lack of bass or a dislocated image in your Paradigm Stereo System could be due to one or more speakers being connected out of phase (reversed polarity). Re-check the speaker cable connections, ensuring that each speaker's cable is connected with the correct polarity: red (+) to red (+) and black (-) to black (-).
Explains amplifier distortion as the primary cause of speaker damage.
Warns about exceeding the speaker's power handling capability.
Positions speakers for accurate timbre by setting drivers at ear level.
Explains speaker placement for balanced bass and clarity.
Explains the benefits and purpose of Anthem Room Correction.
Details the process of Anthem Room Correction.
Guides on proper microphone setup for ARC measurements.
Details the recommended measurement procedure for ARC.
Outlines the fundamental steps for performing ARC measurements.
General| Frequency Response | 42 Hz - 23 kHz ±2dB |
|---|---|
| Sensitivity Room / Anechoic | 94 dB / 91 dB |
| Sensitivity | 94 dB / 91 dB |
| Impedance | 8 ohms compatible |
| Weight | 92 lbs each |
| Type | Hybrid Floorstanding |
| Frequency Response On-Axis | ±2dB from 45 Hz - 23 kHz |
| Tweeter | 1" (2.5cm) AL-MAC™ Ceramic Dome with Oblique Angled Lens (OAL™) tweeter with integrated Perforated Phase-Aligning (PPA™) Lens |
| Low-Frequency Extension | 23 Hz (DIN) |
| Suitable Amplifier Power Range | 15 - 300 W |
| Finish | Walnut, Black Walnut, Piano Black |
| Design | 6-driver, 3-way hybrid floorstanding speaker |
| High-Frequency Driver | 1" (2.5cm) AL-MAC™ Ceramic Dome with Oblique Angled Lens (OAL™) tweeter with integrated Perforated Phase-Aligning (PPA™) Lens |
| Recommended Amplifier Power | 50 - 400 watts |
| Crossover Frequency | 300Hz, 2.2kHz |
To Next Page
