28 |
Magellan & Spectra SP • Installation Guide
Assigning a REM3 Hand-Held 2-Way Remote Keypad to the Panel
Communicator
Test Repor t
Auto Arm
Erase Lost Remote Control
Step Action Details
1
[] + [MASTER CODE]
The [ ] key will flash.
LED/Key on = programmed user
[PARTITION MASTER CODE] may also be used.
2 [user number] 2 digits: 01 to 32
3 [
CODE] Enter 4- or 6-digit code.
4 [
CONFIRM CODE] Re-enter 4- or 6-digit code.
5 [learn remote] Press and hold the Information key ([i]) on the designated remote.
6 [1] and/or [2] + [enter]
Assign the user to one or both partitions and press [
ENTER]. By default users are assigned to partition 1.
Goes to the next available user.
Step Action Details
1
[] + [
MASTER CODE]
The [ ] key will flash.
2 [mem]
3
[3] = Personal Phone #1
[4] = Personal Phone #2
[5] = Personal Phone #3
[6] = Personal Phone #4
[7] = Personal Phone #5
[8] = Pager #
4 [
PHONE #] + [ENTER]
Enter phone # (up to 32 digits) and press [
ENTER]. Goes to next phone#, or go to step 5 if [8] = Pager # was
selected.
5 [
MESSAGE] + [ENTER] Step 5 for Pager # only. Enter pager message and press [ENTER].
Step Action Details
1
[] + [
MASTER CODE]
The [ ] key will flash.
2 [mem] Press the [
MEM] key
3 [2] Send a test report to the monitoring station.
Step Action Details
1
[] + [
MASTER CODE]
The [ ] key will flash.
2[byp]
3
[1] = Auto arm (partition 1)
[2] = Auto arm (partition 2)
4 [hh:mm] Enter time using the 24 hour format (e.g. 18:00 for 6:00 pm).
5
[1] = Regular arm
[2] = Sleep arm
[3] = Stay arm
Step Action Details
1
[] + [
MASTER CODE]
2[byp]
3[3]
4 [all remotes] + [enter] Press a button on all remotes. Press [
ENTER]
5 Press and hold [sleep] (3sec) Press and hold [
SLEEP] to erase all lost remotes.
To Next Page
Loading...
Need help?
General
