Need help?Do you have a question about the Paradox MG5000 and is the answer not in the manual?
General| Partitions | 2 |
|---|---|
| User Codes | 32 |
| Wireless Expansion | Yes |
| Remote Control | Yes |
| Event Buffer | 256 events |
| Wireless Zones | 32 |
| Users | 32 |
| StayD Mode | Yes |
| Input Voltage | 16.5 VAC |
| Number of Zones | 32 |
| Wireless | Yes |
| Supported Detectors | Paradox wireless detectors |
| Event Log | 256 events |
| Zones | 32 |
| PGMs | 2 |
| Remote Controls | 32 |
| Reporting Methods | GSM, GPRS, IP |
| Battery Backup | 12V 7Ah |
Steps for programming user access codes and assigning partitions.
Configuration of entry/exit delays and bell cut-off times.
Configuring automatic arming of the system.
Explains how the system can be divided into partitions for separate security areas.
Instructions for activating and deactivating StayD mode.
How to switch between Stay, Sleep, and Full arming modes.
Explains types of codes and how to program them.
How to arm all zones in a partition using the standard method.
How to arm the system for increased security while allowing movement.
How to arm the perimeter while allowing movement within the premises.
Arm system without code using the [ARM] key.
Arm perimeter without code using the [STAY] key.
Arm zones without code using the [SLEEP] key.
Steps to disarm the system or an alarm using an access code.
To Next Page
