Magellan 9
One-Touch Arming
One-Touch arming allows you to arm the system without using an access code. This feature must be enabled by your installer.
If One-Touch Arming is programmed, you can increase the security level of your system (from Disarm Stay Arm Sleep Arm Full Arm)
without a code. See Figure 4 on page 9.
One-Touch Regular Arming
Press and hold the [ARM] key for 3 seconds to arm all zones in the partition. If partitioned, keys [1] & [2] will flash. You can use this
feature to allow specific individuals like service personnel (e.g. cleaners) to arm without giving them access to any other alarm
system operations. For details see Regular Arming on page 8.
One-Touch Stay Arming
Press and hold the [STAY] key for 3 seconds to arm the perimeter (zones not defined as Stay zones). For details see Stay Arming on
page 8.
One-Touch Sleep Arming
Press and hold the [SLEEP] key for 3 seconds to arm all zones not defined as Sleep zones. For details see Sleep Arming on page 8.
One-Touch Bypass Programming
Press and hold the [BYP] key for 3 seconds to access Bypass Programming Mode. For details see Manual Bypass Programming on
page 10.
Fast Exit
When the system is already Stay or Sleep armed: This feature will allow you to exit already armed premises and keep the system
armed. Press and hold the [
OFF] key for 3 seconds to start the exit delay. After the exit delay has elapsed, the system will switch to
its previous arming mode.
Figure 4: Arming/Disarming
ARM
SLEEP
STAY
OFF
No Code
No Code
No Code
To Disarm:
[
OFF] + Code
To Sleep Arm:
[
SLEEP] + Code
No Code
To Disarm:
[
OFF] + Code
To Stay Arm:
[
STAY] + Code
To Disarm:
[
OFF] + Code
To Next Page
Loading...
Need help?
General
