www.charltonandjenrick.co.uk 9 LT5052 (ISS 5)
These surfaces should be dusted regularly and any marks removed with a soft cloth.
Abrasive or chemical cleaner should never be used.
CLEANING: PILOT ASSEMBLY
In some instances you may experience ignition
problems even when the appliance is new. This may be
due to the aeration hole in the pilot body being partial
blocked with dust, pet hairs or other foreign matter.
The source of this debris could be such things as carpet
fibres, decorating or pet etc.
To clean the pilot, remove the fire front and
ashpan. The pilot is located on the right hand side
of the appliance, any debris in or around the
aeration hole should be remove using the nozzle of
a vacuum cleaner. It is advisable not to blow the
debris into the hole as this may cause more of a
restriction and not rectify the problem.
CLEANING: FAN OUTLET
Warning: -
Before cleaning the fan outlet ensure that the appliance is turned off and cold. In addition isolate the appliance from
the electrical supply (i.e. unplug or switch off at the socket).
If the red light adjacent to the on/off switches
does not extinguish or cycles on and off, it
may be that the fan outlet has become
obstructed (e.g. by plants or other objects) or
the pipe which senses that the fan is operating
correctly has become restricted (e.g. spider,
insects or other debris), particularly if the
appliance has not been used for some time. If
appropriate, remove the obstructions from
the fan outlet and, with the aid of a pipe
cleaner or similar object, clean the pipe
located in the centre of the outlet grille. This
should be checked prior to contacting a
service engineer.
To Next Page
Loading...
Need help?
General
