Paragon EC72 Series User Manual

To Review Date
Step Key Description
1. CLK Current time displayed. Flashing stops.
2. E Current month and date displayed.
3. E Current year displayed.
4. RUN Restores normal operation. Time and day displayed.
Colon flashing.
5. C1/C2 Switching of loads occurs only in the RUN mode. If an
event was scheduled to occur while you where
reviewing information, the event will not have taken
place if you were reviewing during the entire minute
that the event was scheduled to occur. Press C1 or
C2 to initiate override if the status of either circuit is
incorrect.
This applies to programming as well as reviewing.
To Change Time, Day or Date
Step Key Description
1. CLK Currently programmed time displayed. Flashing stops.
2. #### # Enter correct time, then day of week.
3. E Enters new time. Current programmed date displayed.
4. #### Enter new month, then date if either is incorrect.
5. RUN Time and day displayed. Colon flashing.
6. C1/C2 Press C1 or C2 to initiate override if the status of
either circuit is incorrect. See above, Step 5, To
Review Date.
25

Paragon EC72 Series Specifications

General

Brand	Paragon
Model	EC72 Series
Category	Timer
Language	English