P10 INSTALLATION INSTRUCTIONS
Advise The Customer.
The glass front of this fire acts as a dress guard conforming to BS 1945 (1997) and satisfies the
heating appliance regulations (1991) however; a fireguard conforming to BS6539 (1997) must be
used to protect young children, the elderly, or infirm.
During initial “burn off”, an odor may be evident during the first few hours of use. This is due to
the surface coating on the metal work “burning off”. The odor produced is harmless and will
disappear after a short period of time.
Any debris should be cleared from the appliance.
The appliance should be serviced annually by a Gas Safe registered engineer in accordance
with the Service instruction section.
Point out the position of the power source for the appliance, plus demonstrate using the
additional battery holder and adaptor lead, the battery backup option. (“C” cell batteries not
included within this appliance).
Demonstrate the lighting and extinguishing procedures to the user and the removal and refit of
the glass panel for cleaning and the fitting of the battery back up kit.
Hand these instruction over to the user along with the M4 nut spinner for the removal of the glass
panel.
Please be aware that the non-reflective glass may in some lights and from some angles have a
blue tinge to it this is perfectly normal. Also be aware that if the glass liners are fitted in the fire
with the non-reflective glass you will still have a reflection in the glass liners.
To Next Page
Loading...