P10 MAINTENANCE INSTRUCTIONS
Maintenance
To Remove the Burner Carrier Assembly
Remove the glass panel as described on page 6 of the users instruction section.
Remove the Loose shapes.
Remove the two screws retaining the burner Assembly.
Shut off the restrictor elbow and disconnect the 8mm inlet nut.
Switch off the mains supply from the main supply plug socket.
Undo the M3 nut retaining the ECU unit and disconnect the mains supply cable connection.
Take out the six screws retaining the burner tray assembly and lift out of the fire box shelf taking
care not to damage the panels.
To Next Page
Loading...