Extra Thick 11 Gauge
Solid Steel Construction
Interior Locking Cabinet
Resists Hand & Mechanical
Tool Attacks
Opens by Key or Electronic
Lock
Inside Tamper-Proof Hinges
Powder-Coated Interior & Exterior
5 Gun Rack plus 3 Piece Door Rack
Pre-Drilled Holes for Anchoring to Wall
Anchor Bolts Included
Commandant D 7500 Digital Lock
Rifle/Gun Safe
Copyright 2010 DTX International
9
SPECIFICATIONS
Model
Material
Bolt
Dimensions
Steel
Commandant D
7500
25mm/1in. 57”H x 13.7”W x 12”D
HOW TO USE YOUR COMMANDANT
Before using your safe:
1. First, remove the center cover of the key plate on the outer door keypad
and open the door with the key provided (Figure A).
IMPORTANT: Please do not store the outer door keys in your safe!
2. Next, remove the battery cover plate located on the inside of the outer
door and install the 4 AA 1.5V batteries provided (Figure B). Replace
the battery cover.
To setup or change a user passcode:
1. With door open, locate the red button on the back of door near the hinge
(Figure C). Press the red button, listen for a beep and then enter your
new user passcode. New user passcodes may be 3 to 6 digits long.
2. Immediately after entering your new code, press the “A” or “B”
button on the keypad. Your new user code is now stored.
Note: This safe stores up to 2 passcodes simultaneously; a user
code and a manager code. Entering a third code will erase
the first passcode entered.
Your safe comes with 2 separate sets of keys, one for the
exterior door and one for the interior locking cabinet.
Please do not store keys in safe! Keep secure in a safe
place.
7500 Keypad
7500 Keypad
Figure A
Figure B
Figure C
To Next Page
Loading...
