1-800-443-4859
The Power to Bring People and Places Together !
All information, drawings, flowcharts, and schematics are the
property of Parallax Power Supply L.L.C. All rights reserved.
Refer installation and servicing to qualified service
personnel. Service information provided solely for use by
Licensed Electricians and Certified RV Technicians. No
endorsement of technical expertise, arising from the use of the
information supplied is either expressed or implied.
7300 Series DC Wiring
1. Converter DC output lead.
2. Converter “reverse battery polarity”
protection fuses.
3. “C” Terminal – Connect to battery
Positive wiring. # 8 CU AWG
minimum w/ 90 degree Celsius
insulation rating required.
4. “D” Terminal – Connect to 12 volt
load Negatives and battery Negative.
# 8 CU AWG minimum w/ 90 degree
Celsius insulation rating required.
5. 12 Volt load circuit Positive
connection terminals. Fuse each load
circuit per NEC Code (Table 310-16)
appropriate to AWG and temperature
rating of conductor used.
12 VDC installation shall comply with
ANSI/RVIA 12 V
GR series terminal bar
recommended.
DC load circuits
+
+
1 2
3
4
5
+
Product shown with Door and dead front plate removed.
To Previous Page
Loading...