Parallax ATS 5070 FI - User Manual

To Next Page

MOUNTING LOCATION

Qualified service personnel should install the ATS 5070 series

meeting all applicable codes and standards.

The ATS 5070 series may be mounted in any position, leaving room for

routing shoreline, generator and load conductors. To minimize voltage

drop in the wiring the transfer switch should be located as close to the

generator and shoreline cord entrance as practical.

DO NOT mount the ATS 5070 series in the generator compartment.

The ATS 5070 series is not ignition protected, and therefore should not

be mounted in the same compartment as batteries or flammable materials

such as gasoline. It may be mounted in the cabin or living area or a

basement compartment, but is not suitable for outside locations.

SPECIFICATIONS

**Electrical rating: 120/240 volts AC 60 HZ @ 50amperes.

Maximum generator: 12KW

Enclosure: UL Type 1 16 GA Steel

Listed for US and Canadian applications.

**Note: L1 and L2 rated 35 amperes per leg with 70 ampere neutral when L1 and

L2 are in phase. (Optional jumpers must be installed).

Model Dimensions Weight

ATS 5070 8”L x 8”W x 4.75” D 7.5 lbs.

ATS 5070 FI 10.25”L x 8.25”W x 5.25” D 10.5 lbs.

ATS 5070 MB 11.25”L x 8.25”W x 5.25”D 9.5 lbs.

Not ignition protected.

Specifications subject to change without prior notice.

WARRANTY STATEMENT

Parallax warrants each ATS 5070 model to be free from defects in materials and

workmanship under normal use and service and limits the remedies to repair or

replacement. This warranty extends for two years from the date of purchase and

only valid to the original owner and within the continental limits of the United

States and Canada. If a problem should occur within the first 24 months of

purchase, please contact a dealer that handles warranty service on your

Recreational Vehicle.

You may download the entire Parallax Warranty Policy at:

http://www.parallaxpower.com/warranty_policy

No user serviceable parts inside. This warranty does not cover damage due to

improper installation, abuse or accidents.

425 Sycamore St. Anderson, IN 46016

Phone: 800-443-4859 Fax: 765-608-5235

For a special offer concerning

Extended Warranty Coverage,

Visit our website at

www.parallaxpower.com

AUTOMATIC LINE/GENERATOR

TRANSFER SWITCH

MODEL ATS 5070 SERIES

Operator Guide

ATS 5070 FI

(Flanged Inlet)

PN # 999-8000-060

Form # 80060 Rev F

ATS 5070

ATS 5070 MB

(Mounting Bracket)

Need help?

Do you have a question about the Parallax ATS 5070 FI and is the answer not in the manual?

Summary

Mounting Location

Generator Compartment Restriction

Prohibits mounting the ATS 5070 in the generator compartment due to ignition protection concerns.

Mounting Location Guidelines

Details safe mounting locations, avoiding compartments with batteries or flammable materials.

Specifications

Model Specifications

Lists dimensions and weight for different ATS 5070 models (ATS 5070, ATS 5070 FI, ATS 5070 MB).

Warranty Statement

Warranty Coverage

Details the two-year warranty for defects in materials and workmanship for the ATS 5070 series.

Warranty Exclusions

Specifies that the warranty excludes damage from improper installation, abuse, or accidents.

Introduction

General Information

Operation

From Shoreline

Explains how the ATS 5070 connects to shoreline power for appliance operation.

From Generator

Details the automatic transfer process from generator power after a delay.

Auxiliary Contact Operation

Typical Installations

Illustrates wiring diagrams for ATS 5070 series installation with load connections.