Check for Leaks
Your patio heater has been checked at all factory connections for leaks, but
you should always check when you attach the LPG cylinder. To check for
leaks, following these instructions:
--Assemble all gas connections;
--Connect regulator assembly to the propane tank;
--Make sure the heater valve is turned OFF.
1) Make soapy solution by mixing 1 part liquid dish soap and 3 parts water.
2) Open the propane tank valve.
3) Spray of the soapy solution onto the
gas hose /regulator and regul ator/cylinder connection.
4) Inspect the connections and look for bubbles.
5) If no bubbles appear the connection is safe.
6) If bubbles appear, there is leakage. Close the propane tank valve, and
loosen and re-tighten this connection.
7) Check for leakage again.
ASSEMBLY
- 11 -
To Next Page
Loading...
Need help?
General
