CAUTON:
Avoid inhaling fumes emitted from the heater’s first use.
Smoke and odor from the burning of oils used in manufacturing will
appear. Both smoke and odor will dissipate after approximately 30
minutes. The heater should not produce thick black smoke.
Note:
The burner may be noisy when initially turned on. To eliminate
excessive noise from the burner, turn the control knob to the
“LO” position, then turn the knob to the level of heat desired.
Warning : White smoke may appear around the radiant
head during the first minutes of the initial burning.
When heater is ON:
Emitter screen will become bright red due to intense heat.
The color is more visible at night. Burner will dis
play tongues
of blue flame. These flames should not be yellow or produce
thick black smoke, indicating an obstruction of airflow through
the burners. If the flame is very small, it indicates that
gass pressure is not enough.
Relighting the heater:
1) Turn the control knob to “OFF” position.
2) Wait five (5) minutes before attempting to relight flame.
3) Repeat steps beginning with step 2 on page 14.
Before leaving the heater unattended:
1) Turn the control knob to “OFF” position and turn LP
cylinder to “OFF” position.
2) Never leave the patio heater unattended while in use.
Shut down instructions
1) Push in and turn control knob clockwise to “OFF” position.
2) Turn LP tank gas valve clockwise to “OFF” position when
heater is not in use.
NOTE: After use, some discoloration of the emitter screen is
normal.
If you suspect gas leakage:
1) Turn the control knob to “OFF” position.
2) Turn LPG cylinder to “OFF” position.
3) Wait 5 minutes to allow gas to dissipate.
4) If odor continues, immediately call your gas supplier.
Warning: Heater will be hot after use.
Handle with extreme care.
OPERATION
- 15 -
To Next Page
Loading...
Need help?
General
