TWP/TWB200 – TWP/TWB9000
39
1. Heated and Heatless Operation Mode Buttons
Press to start dryer, or switch between heated and heatless mode.
When switching modes, you must wait for the mode transition to complete before
you can switch back.
2. Test Drains
Press to open the drain valve for the amount of time determined by Drain Duration setting.
3. Backup and Restore PLC Settings
Used to store a copy of the PLC settings so they can be transferred to a replacement PLC.
4. Reboot Display
Used to reboot the display panel should it be necessary.
An alternate method it to pull the orange plug on the back of the display panel.
5. Exit to System
Exits the application so that system level settings, such as communications
can be accessed.
6. Time/Date Set
Press to adjust the time and date.
See note in trending section for possible effects on data logging and trends.
7. Reference Guide
Press to access Reference Guide.
Use the onboard reference guide to learn about and troubleshoot dryer functions.
To Next Page
Loading...
Need help?
General