Parker IQAN-MD4 - Module Display and Input Specifications; LCD MD4-10 (10.1 inch) Specifications; Sensor Supply VREF Specifications; Signal Input VIN Specifications

29
IQAN-MD4 Technical Overview
Appendix A
Instruction book, IQAN-MD4
LCD - MD4-10 (10.1 inch)
Resolution 800 x 600 dots
Number of Colors 262 K
Active area 211 x 158 mm
Brightness
1000 cd/m
2
(reduced to 50% if V
BAT
<14 V)
Viewing angle 80 degree all directions
Contrast Ratio 400
Maximum allowed dot-defect
(1 dot / 2 adj. dot) Bright dot 4/2, Dark dot 5/2
Touch sensor PCAP
Sensor supply - VREF
Number of VREF 1
Output voltage 5 V ±150 mV, -30 to 70 °C
Output voltage temperature drift 0.50 mV/°C
Maximum load current 50 mA
Protection over load, SCB, SCG
Diagnostics over/under voltage
Under/over voltage threshold ±150 mV from nominal value
Signal input - VIN
Number of VIN 2 (configuration may reduce number)
VIN full scale 5000 mV ±100 mV
VIN resolution 12 bits = 1.22 mV
Input impedance 36 kohm in parallel with 10 nF
Accuracy ± (1% + 25mV)
Sample rate Same as system cycle time T
SC
Maximum continuous voltage 32V
Protection SCB, SCG
Diagnostics defined in application
Signal input - DIN
Number of DIN 10 (configuration may reduce number)
Logic levels
low
high
hysteresis
<0.5 V
>3 V
>150 mV
Input impedance 6.8 kohm
Sample rate Same as system cycle time T
SC
Maximum continuous voltage 32 V
Diagnostics defined in application