10
11
BLOW PIPE INSTALL
NOTE: The pipe is a tight t to ensure that the vacuum is air tight!
1. Attach blow pipe B to the machine, rotate and screw to x.
2. Attach blow A to B by rotating.
Blow pipe A
Blow pipe B
Push, twist and turn
ASSEMBLY
FILLING THE FUEL TANK
WARNING!
Danger of re and burn injury!
■ Always use extreme care when handling petrol. It is highly
ammable.
■ Never operate this blower if fuel system components are
damaged or are leaking.
■ Never attempt to refuel a hot engine! Always allow the
blower engine to cool before refuelling!
■ Don’t smoke or light any res near the blower or stored
fuel.
■ Always transport and store after ensuring the exhaust.
■ Only operate the blower after ensuring the exhaust is
functioning properly.
■ Never operate the blower unless it is properly assembled
and in good working condition.
FILLING PROCEDURE
1. Stop the machine, and place on the ground or on a sturdy work
surface, and wipe any debris from around the fuel cap.
2. Remove the fuel cap.
Remove the
fuel ller cap
To Next Page
Loading...