12
LabTec Methadone Dispenser: Overview
The LabTec Methadone Dispenser provides high precision, high accuracy, and programmable
Methadone dispensing capability. The LabTec utilizes an optically encoded, servo-controlled motor,
assuring a highly reproducible pump performance. The LabTec system comes with an RH1CKC
piston pump head (Parker P/N: 080-402) which is powered by 3400 RPM motor (Parker P/N: 010-
017-2).
The LabTec has been used for many years on a nationwide and now international basis, and
provides long term accurate service in the dispensing of Methadone and the control of inventory in
the clinic when properly maintained and calibrated.
PumpSense™: Pump Overload Protection
When Methadone is allowed to dry inside the piston pump head, the LabTec software will recognize
this condition and go into a stand-by mode, the pump motor is turned off and the following message
is displayed:
Before continuing with your pumping application, immediately replace the methadone container with
your cleaning solution, press the A button twice to return to the normal screen and try dispensing
again. If this works, run the solution for at least 2 minutes before flushing and returning to normal
operations. If the situation continues, contact Parker Customer Service for assistance. The
PumpSense™feature has been implemented as a failsafe device to protect your pump head and
motor from permanent damage.
NOTE: Parker has implemented a LabTec preventative maintenance and loaner program.
Send in your LabTec unit to Parker for pump head cleaning and seal replacement. The
service also includes functional test, calibration as well as a written performance validation.
The typical turn-around time for LabTec repairs is 10 business days. You can rent a LabTec
loaner from Parker while your unit is being serviced.
Contact your Parker TM or Technical Support at 805-604-3400 To obtain the appropriate form and
TSP number prior to shipping your unit in for service.
CHECK PUMP HEAD
Press Any Key
To Next Page
Loading...